Remote Control
If you are simply replacing a TV to be used with an existing remote and video stream, proceed with the following instructions.
SRC-200
Programming your SRC-200 Remote Control
Programming Remote to a TV
- Start with the TV turned on.
- Press and hold the MUTE button until the light starts flashing.
- Press and release the POWER button: The light will stop blinking and remain solid.
- Press the ARROW UP button (between GUIDE & SELECT) repeatedly until the TV turns off.
- Press the SELECT button.
SRC-300A
Programming your SRC-300A Remote Control.
Programming Remote to a TV
- Press the LED button and hold it down until the LED Flashes.
- Press the REC button. The LED stops blinking at this point and stays solid.
- Press and release the POWER. The remote is now in TV Code Scan Programming Mode.
- Press the UP ARROW (above SELECT) button to scan through all the TV codes. When you reach the correct TV code, the TV will automatically turn off.
- Press the SELECT button to store the TV code. The LED flashes rapidly then stops, indicating code has been stored.
SRC-350A
Programming your SRC-350A Remote Control.
Programming Remote to a TV
- Turn on the TV you wish to program the remote to.
- Press and hold the SELECT and MUTE buttons on your remote control at the same time. When the LED indicator turns solid red, release the buttons.
- Press the UP ARROW button multiple times until the TV turns off. This may take several times of pressing and releasing the UP ARROW button.
- Once your TV turns off, press the SELECT button to store the TV code.
- Your remote should now be programmed to power the TV on or off, and adjust the volume.
